It is the advantage of the many makes liquid crystal splicing the pace of development in the market and no one can, including the number and the number of users is growing rapidly. But as the LCD splicing system more and more users, found that the problem is more and more. Often there will be a net friend to net feedback projection era, LCD splicing system used in the usual process of exactly what to notice? The service life of how to make the system more? Don't worry, here is a look.

LCD splicing screen due to long time work is very easy to make some pixels to overheat, once more than the limit will result in permanent damage, this creates a often said "bad points". As a result of the LCD splicing screen pixels is constructed by LCD, so when working 96 hours continuously at full capacity, will accelerate the aging, serious when even will burn out. So, if a user must work for a long time, it is best to let it rest for a while, intermittently or not with the time interval used to change the screen content, are in a state of waiting for work to reduce brightness because it is over, or its operations in screen saver mode for a while, this little effort not only can delay the ageing of the LCD screen, and can prevent damage of hardware.

LCD whether what problem, also banned assembly LCD splicing screen itself (special interest in general DIY especially), once the LCD splicing screen don't work properly can look for vendors to help solve. Of LCD background illumination by the components of transformer in power off after a certain period of time still may have high voltage 1000 v (albeit micro electric current), and laypeople if processes is not good may cause new fault components.

Moreover, LCD display screen is very fragile too, impact resistant ability is poor. This is because the LCD contains a lot of precision components and agile fragile glass electrical components, once strong impact, will lead to the LCD screen and other related parts damaged. So be sure to avoid the impact of the strong shock. At the same time, notice not to put pressure on the surface of the LCD screen, such as show a part of the screen with your fingers, it is very easy to cause bad points to add much.

In addition, if once found have dirt on the surface of the LCD splicing screen, clear the dirt accurate method should be used. Using the best media is soft, the fiber material, such as cotton wool, lens paper or soft cloth, etc., and then touch a little glass cleaner to wipe gently, it is prohibited to use alcohol kind of chemical solutions, also cannot use coarse cloth or paper goods, because this kind of material are prone to scratches. Here to remind you is, don't put clean appeared spray directly to the screen surface, it flow into the screen very easily lead to the LCD screen internal short circuit fault, cause needless loss.